Go to Forum Home › Building Simulation › PHPP – Opaque exterior door

Viewing 1 reply thread
  • Author
    Posts
    • 17 August 2014 at 11:31 am #31890
      A-tec Design
      Participant

        In PHPP you have to enter an opaque door in the areas worksheet, with a single U-value.

        Where doe the psi value for the installation get entered?

      • 5 September 2014 at 9:09 pm #39172
        Mark Siddall
        Participant

          You can use the thermal bridge inputs further down the worksheet.

          M

      • Author
        Posts
      Viewing 1 reply thread
      • You must be logged in to reply to this topic.